>

Hyundai Equus: 4&OD Clutch Control Solenoid Valve Specifications - Automatic Transmission Control System - Automatic Transmission System (SBC) - Hyundai Equus VI 2009-2026 Service ManualHyundai Equus: 4&OD Clutch Control Solenoid Valve Specifications

Specifications
Direct control VFS[4&OD/C]
x Control type : Normal high type
Control Pressure kpa (kgf/cmx, psi)
0~1569.06
(0~16,0~227.57)
Current value(mA)
0~1100
 Internal resistance(x)
5.0~5.6

    4&OD Clutch Control Solenoid Valve Description and Operation
    Description 4&OD Clutch control solenoid valve is attached to the valve body. This variable force solenoid valve directly controls the hydraulic pressure inside the 4&OD Clutch. ...

    4&OD Clutch Control Solenoid Valve Schematic Diagrams
    Circuit Diagram ...

    See also:

    Steering Wheel Remote Controller (SWRC) Troubleshooting
    Initialization and Troubleshooting Procedures 1. Initialization Procedure : Disconnect (connector or battery) for 30 seconds (time required for internal condenser discharge), then reconnect the p ...

    Repair procedures
    Removal     • Put on gloves to protect your hands.     • Use seat covers to avoid damaging any surfaces. 1. Remove the roof side molding. ...

    Checking the engine oil level
    1. Be sure the vehicle is on level ground. 2. Start the engine and allow it to reach normal operating temperature. 3. Turn the engine off and wait for a few minutes (about 5 minutes) for the oil ...

    Categories

    Hyundai Equus Manuals

    © 2011-2026 Copyright www.heqmanual.com