>
Inspection |
1. |
Turn ignition switch OFF. |
2. |
Disconnect the E Module connector. |
3. |
Measure resistance between sensor signal terminal and sensor ground terminal. |
4. |
Check that the resistance is within the specification. |
A/V Mode
This mode displays the state of the A/V system. ...
Compressor Components and Components Location
Components
1. Center Bolt2. Hub Bolt3. Hub Assembly4. Snap Ring5. Pulley6. Compressor Assembly
...
Starter Relay Repair procedures
Inspection
1.
Disconnect the battery negative terminal.
2.
Remove the fuse box cover.
3.
Remove the starter relay(A).
4.
Using an ohmmeter, check that there is continuity between each ...