>
Inspection |
1. |
Turn ignition switch OFF. |
2. |
Disconnect the E Module connector. |
3. |
Measure resistance between sensor signal terminal and sensor ground terminal. |
4. |
Check that the resistance is within the specification. |
Brake Line Repair procedures
Removal
1.
Remove the wheel & tire.
2.
Remove the brake hose clip (A).
Front
Rear
3.
Disconnect the brake tube by loosening the tube flare nut.
Tightening torque :
12.7 ~ 16.7 N ...
Mode Control Actuator Description and Operation
Description
The mode control actuator is located at the heater unit.
It adjusts the position of the mode door by operating the
mode control actuator based on the signal of the A/C control unit. ...
Distance to distance vehicle sensor
The sensor detects distance to the vehicle ahead.
If the sensor is covered with dirt or other foreign matter, the vehicle to vehicle
distance control may not operate correctly.
Always keep the ...