>
Hyundai Equus Manuals

Hyundai Equus: Inhibitor Switch Specifications - Automatic Transmission Control System - Automatic Transmission System (SBC) - Hyundai Equus VI 2009-2026 Service ManualHyundai Equus: Inhibitor Switch Specifications

Second generation VI (2009–2026) / Hyundai Equus VI 2009-2026 Service Manual / Automatic Transmission System (SBC) / Automatic Transmission Control System / Inhibitor Switch Specifications

Specifications
x Type: Combination of output signals from 4 terminals
Power supply (V)
12
Output type
Combination of output signals

Signal Code Table
PIN No.
P
P-R
R
R-N
N
N-D
D
S1
12V
12V
O
O
O
O
O
S2
O
12V
12V
12V
O
O
O
S3
O
O
O
12V
12V
12V
O
S4
O
O
O
O
O
12V
12V

    Inhibitor Switch Description and Operation
    Description Inhibitor Switch monitors the lever's position(PRND) and is used to control gear setting signals. ...

    Inhibitor Switch Schematic Diagrams
    Circuit Diagram ...

    See also:

    LDWS operation
    To operate the LDWS, pull the switch with the Engine Start/Stop Button in the ON position. The indicator illuminates on the cluster. To cancel the LDWS, pull the switch again. LDWS indicator li ...

    If engine turns over normally but does not start
    1. Check fuel level. 2. With the Engine Start/Stop Button in the OFF position, check all connectors at ignition coils and spark plugs. Reconnect any that may be disconnected or loose. 3. If the en ...

    Rear Door Outside Handle Repair procedures
    Replacement 1. Remove the hole plug (B). 2. After loosening the mounting bolt, then remove the rear door outside handle cover (A). Tightening torque : 6.9 ~ 10.8 N.m (0.7 ~ 1.1 kgf.m, 5.1 ...

    Categories

    Hyundai Equus Manuals

    © 2011-2026 Copyright www.heqmanual.com