>

Hyundai Equus: General Information - Body Dimensions - Body (Interior and Exterior) - Hyundai Equus VI 2009-2026 Service ManualHyundai Equus: General Information

General
1.
Basically, all measurements in this manual are taken with a tracking gauge.
2.
When a measuring tape is used, check to be sure there is no elongation, twisting or bending.
3.
For measuring dimensions, both projected dimension and actual-measurement dimension are used in this manual.
Measurement method
Projected dimensions
1.
These are the dimensions measured when the measurement points are projected into the reference plane, and are the reference dimensions used for body alterations.
2.
If the length of the tracking gauge probes are adjustable, make the measurement by lengthening one probe by the amount equivalent to the difference in height of the two surfaces.

Actual-measurement dimensions
1.
These dimensions indicate the actual linear distance between measurement points, and are the reference dimensions for use if a tracking gauge is used for measurement.
2.
Measure by first adjusting both probes to the same length (A=A')
   
Check the probes and gauge itself to make sure there is no free play.

Measurement point
1.
Measurements should be taken at the hole center.

    Body Dimensions
    ...

    Sedan Front Body
    Front body A Roof panel front cornerFront pillar outer cornerHood hinge mounting hole (O13)Shockabsorber mounting hole (O24)Front end module mounting hole (O9)Cowl top cover mounting hole (O7) F ...

    See also:

    This device complies with Part 15 of the FCC rules.
    Operation is subject to the following two conditions: 1. This device may not cause harmful interference, and 2. This device must accept any interference received, including interference that may c ...

    Wheel alignment and tire balance
    The wheels on your vehicle were aligned and balanced carefully at the factory to give you the longest tire life and best overall performance. In most cases, you will not need to have your wheels al ...

    Lumbar Support Unit Repair procedures
    Removal 1. Disconnect the negative (-) battery terminal. 2. Remove the rear seat back. (Refer to Body - "Rear Seat Back Cover") 3. Remove the bladder & ECU/ valve assembly (A) after l ...

    Categories

    Hyundai Equus Manuals

    © 2011-2026 Copyright www.heqmanual.com