Hyundai Equus: General Information
Second generation VI (2009–2026) / Hyundai Equus VI 2009-2026 Service Manual / Body (Interior and Exterior) / Body Dimensions / General Information
Second generation VI (2009–2026) / Hyundai Equus VI 2009-2026 Service Manual / Body (Interior and Exterior) / Body Dimensions / General Information
| General |
| 1. |
Basically, all measurements in this manual are taken with a tracking gauge. |
| 2. |
When a measuring tape is used, check to be sure there is no elongation, twisting or bending. |
| 3. |
For measuring dimensions, both projected dimension and actual-measurement dimension are used in this manual. |
| Measurement method |
| Projected dimensions |
| 1. |
These are the dimensions measured when the measurement
points are projected into the reference plane, and are the reference
dimensions used for body alterations. |
| 2. |
If the length of the tracking gauge probes are adjustable,
make the measurement by lengthening one probe by the amount equivalent
to the difference in height of the two surfaces.
|
| Actual-measurement dimensions |
| 1. |
These dimensions indicate the actual linear distance between
measurement points, and are the reference dimensions for use if a
tracking gauge is used for measurement. |
| 2. |
Measure by first adjusting both probes to the same length (A=A')
|
| Measurement point |
| 1. |
Measurements should be taken at the hole center.
|
Body Dimensions
...
Sedan Front Body
Front body A
Roof panel front cornerFront pillar outer cornerHood hinge mounting hole (O13)Shockabsorber mounting hole (O24)Front end module mounting hole (O9)Cowl top cover mounting hole (O7)
F ...
See also:
Loss of a Smart Key
A maximum of three Smart Keys including Card Type Smart Key can be registered
to a single vehicle. If you happen to lose your Smart Key, you should immediately
take the vehicle and remaining key t ...
Drive shafts and boots
Check the drive shafts, boots and clamps for cracks, deterioration, or damage.
Replace any damaged parts and, if necessary, repack the grease. ...
Underdrive Brake Control Solenoid Valve(UD/B_VFS) Repair procedures
Inspection
1.
Turn ignition switch OFF.
2.
Disconnect the E Module connector.
3.
Measure resistance between sensor signal terminal and sensor ground terminal.
4.
Check that the res ...
Categories
Hyundai Equus Manuals
© 2011-2026 Copyright www.heqmanual.com