>

Hyundai Equus: Brake Line Repair procedures - Brake System - Brake System - Hyundai Equus VI 2009-2024 Service ManualHyundai Equus: Brake Line Repair procedures

Removal
1.
Remove the wheel & tire.
2.
Remove the brake hose clip (A).
Front

Rear

3.
Disconnect the brake tube by loosening the tube flare nut.

Tightening torque :
12.7 ~ 16.7 N.m (1.3 ~ 1.7 kgf.m, 9.4 ~ 12.3 lb-ft)

4.
Disconnect the brake hose from the brake caliper by loosening the bolt. And loosen the braket bolt for disconnect the brake line.

Tightening torque :
24.5 ~ 29.4 N.m (2.5 ~ 3.0 kgf.m, 18.1 ~ 21.7 lb-ft)

Front

Rear

Inspection
1.
Check the brake tubes for cracks, crimps and corrosion.
2.
Check the brake hoses for cracks, damage and fluid leakage.
3.
Check the brake tube flare nuts for damage and fluid leakage.
4.
Check the brake hose mounting bracket for crack or deformation.
Installation
1.
Installation is the reverse of removal.
   
Use a new washer (A) whenever installing.

2.
After installation, bleed the brake system.
(Refer to Brake System - "Brake System Bleeding")
3.
Check the spilled brake oil.
    Brake Line Components and Components Location
    Components ...

    Brake Pedal Components and Components Location
    Components 1. Brake pedal member assembly2. Stop lamp switch3. Clevis pin 4. Snap pin5. Brake pedal 6. Return spring7. Bolt ...

    See also:

    8LR Brake Control Solenoid Valve Schematic Diagrams
    Circuit Diagram ...

    ETC (Electronic Throttle Control) System Specifications
    Specification [Throttle Position Sensor (TPS)] Throttle angle(°)Output Voltage (V)TPS1TPS200.54.5100.964.05201.413.59301.873.14402.322.68502.782.23603.231.77703.691.32804.140.86904.60.41984.650.35 ...

    Auto hold
    The AUTO HOLD feature keeps the brakes applied after the vehicle comes to a complete stop when the shift lever is in D, R, or N. The brakes release when throttle is applied. Set up 1.Pre ...

    Categories

    Hyundai Equus Manuals


    © 2011-2024 Copyright www.heqmanual.com