>
Hyundai Equus: Knee Airbag (KAB) Module Repair procedures
| Removal |
| 1. |
Disconnect the battery negative cable and wait for at least three minutes before beginning work. |
| 2. |
Remove the crash pad lower panel.
(Refer to Body - "Crash Pad Lower Panel") |
| 3. |
Remove the knee airbag (C) after loosening the srcrews (A) and nuts (B).
|
| Installation |
| 1. |
Turn the ignition switch OFF. |
| 2. |
Disconnect the battery negative cable and wait for at least three minutes. |
| 3. |
Tighten the knee airbag mounting screws (A) and nuts (B).
|
| 4. |
Install the crash pad lower panel.
(Refer to Body - "Crash Pad Lower Panel") |
| 5. |
Reconnect the battery negative cable. |
| 6. |
After installing the knee airbag, confirm proper system operation:
Turn the ignition switch ON; the SRS indicator light should turn on for about six seconds and then go off. |
Knee Airbag (KAB) Module Components and Components Location
Airbag Module Disposal Description and OperationVSM OFF Switch Repair procedures
Removal
1.
Disconnect the negative (-) battery terminal.
2.
Remove the airbag module.
(Refer to Restraint - "Driver Airbag (DAB) Module and Clock Spring")
3.
Remove the TORX screws to rem ...
Smart Cruise Control Unit Description and Operation
Description
The smart cruise control unit is installed on the front
center of the chassis. A radar sensor is embedded in the front section
of the unit. This sensor detects vehicles and objects ...
Fuel lines, fuel hoses and connections
Check the fuel lines, fuel hoses and connections for leakage and damage. Have
an authorized EQUUS dealer replace any damaged or leaking parts immediately. ...