>
Hyundai Equus: Repair procedures
| Service Adjustment Procedure |
| 1. |
Turn the steering wheel so that the front wheels can face straight ahead. |
| 2. |
Measure the distance that the steering wheel can be turned without moving the front wheels.
|
| 3. |
If the play exceeds standard value, inspect the steering column, shaft, and linkages. |
| 1. |
Position the vehicle on a level surface and place the steering wheel in the straight ahead position. |
| 2. |
Start the engine and turn the steering wheel from lock to lock several times to warm up the power steering fluid. |
| 3. |
Attach a spring scale to the steering wheel. With the engine
speed 900 ~ 1100rpm, pull the scale and read it as soon as the tires
begin to turn.
|
| 4. |
If the measured value exceeds standard value, inspect the power steering gear box and pump. |
Always use genuine PENTOSIN CHF202. Using other type of power
steering fluid or ATF can cause increased wear and poor steering in
cold weather. |
| 1. |
Raise the reservoir and then disconnect the return hose to
drain the reservoir. Be careful not to spill the fluid on the body and
parts. Wipe off any spilled fluid at once. |
| 2. |
Connect a tube of suitable diameter to the disconnected return hose, and put the hose end in a suitable container. |
| 3. |
Jack up the front wheels and turn the steering wheel from the lock to lock until fluid stops running out of the tube. |
| 4. |
Reconnect the return hose to reservoir. |
| 5. |
Fill the reservoir with the power steering fluid and then bleed the power steering system. |
Always use genuine PENTOSIN CHF202. Using other type of power
steering fluid or ATF can cause increased wear and poor steering in
cold weather. |
| 1. |
Jack up the front wheels. |
| 2. |
Fill the reservoir with the power steering fluid up to the level of 'COLD MAX' marked on the reservoir.
|
| 3. |
Turn the steering wheel from lock to lock 5 ~ 6 times for 15 ~ 20 seconds. |
| 4. |
Crank the engine 1 ~ 2 times by turning the ignition key very
quickly from the 'On' position to the 'Start' position, but do not
start the engine. |
| 5. |
Turn the steering wheel from lock to lock 5 ~ 6 times for 15 ~ 20 seconds. |
| 6. |
Start the engine and keep turning the steering wheel from
lock to lock until air bubbles stop appearing in the reservoir with the
engine idle. |
| 7. |
Check the color and level of the power steering fluid in the
reservoir and then replenish the reservoir up to the 'COLD MAX' level as
required.
|
Troubleshooting
Steering wheelESP OFF Switch Description and Operation
Description
1.
The ESP OFF switch is for the user to turn off the ESP system.
2.
The ESP OFF lamp is on when ESP OFF switch is engaged. ...
Compressor Components and Components Location
Components
1. Dyer2. Motor3. Connected to tube4. Reverse valve connector5. Connector for motor driveing
...
Warning Messages
Shift to "P" or "N" to start engine
This warning message illuminates if you try to start the engine with the
shift lever not in the P (Park) or N (Neutral) position.
...