>
Hyundai Equus: Rear Variable Damper Repair procedures
| Removal |
| 1. |
Remove the rear wheel & tire.
|
| 2. |
Disconnect the rear shock absorber (A) from the rear axle by loosening the bolt.
|
| 3. |
Loosen the mounting bolt (A) and then remove the rear shock absorber.
|
| 4. |
Installation is the reverse of removal. |
| Inspection |
| 1. |
Check the components for damage or deformation. |
| 2. |
Compress and extend the piston rod (A) and check that there is no abnormal resistance or unusual sound during operation.
|
| 1. |
Fully extend the piston rod. |
| 2. |
Drill a hole on the (A) section to discharge gas from the cylinder.
|
Rear Variable Damper Schematic Diagrams
Air Spring Components and Components LocationFloor mat anchor(s) (if equipped)
When using a floor mat on the front floor carpet, make sure it attaches to the
floor mat anchor(s) in your vehicle.
This keeps the floor mat from sliding forward.
WARNING
The following must be ...
Canister Repair procedures
Removal
1.
Turn the ignition switch OFF and disconnect the negative (-) battery cable.
2.
Remove the service cover (A).
3.
Disconnect the fuel tank pressure sensor connector (A) and the ...
Rear Door Outside Handle Components and Components Location
Component Location
1. Rear door outside handle
...