>
Hyundai Equus: Power Mosfet Repair procedures
| Inspection |
| 1. |
Turn the ignition switch ON. |
| 2. |
Manually operate the control switch and measure the voltage of the blower motor. |
| 3. |
Select the control switch to raise the voltage until high speed.
Specification
|
| 4. |
If the measured voltage is not within specification, substitute with a known-good power mosfet and check for proper operation. |
| 5. |
Replace the power mosfet if it is proved that there is a problem with it. |
| Replacement |
| 1. |
Disconnect the negative (-) battery terminal. |
| 2. |
Remove the cowl side trim.
(Refer to Body - "Cowl Side Trim") |
| 3. |
To remove the crash pad under cover [RH] (A), press both sides of the locking pin and then pull it down.
|
| 4. |
Disconnect the under lamp connector (A).
|
| 5. |
Disconnect the power mosfet connector (A) and then remove the power mosfet (B) after loosening the mounting screws.
|
| 6. |
Install in the reverse order of removal. |
Blower Motor Repair procedures
Climate Control Air Filter Description and OperationSpecifications
Specifications
ItemsSpecificationsRated voltage5VLoadMax. 1mA (Relay load)Detection illuminationsTail lampON : 74 ± 16 (Lux), 2.36 ± 0.08 (V)OFF : 148 ± 32 (Lux), 4.52 ± 0.1 (V)Head lampON : ...
If the engine stalls at a crossroad or crossing
If the engine stalls at a crossroad or crossing, set the shift lever in the N
(Neutral) position and then push the vehicle to a safe place. ...
Front Rear Parking Assist System Switch Repair procedures
Removal
1.
Disconnect the negative (-) battery terminal.
2.
Remove the crash pad lower panel.
(Refer to Body - "Crash Pad Lower Panel")
3.
Remove the crash pad lower panel and then push t ...