>

Hyundai Equus: Rearview camera (If equipped) - Features of your vehicle - Hyundai Equus 2009-2026 Owners ManualHyundai Equus: Rearview camera (If equipped)

 

The rearview camera will activate when the back-up light is ON with the ignition


The rearview camera will activate when the back-up light is ON with the ignition switch ON and the shift lever in the R position.

This system is a supplemental system that shows behind the vehicle through the navigation display while backing-up.

WARNING

  • This system is a supplementary function only. It is the responsibility of the driver to always check the inside/outside rearview mirror and the area behind the vehicle before and while backing up.
  • Always keep the camera lens clean. If the lens is covered with foreign matter, the camera may not operate normally.

✽ NOTICE

The rearview camera may not operate normally, when you drive in the extremely high or low temperature areas (operating temperature : -4°F ~ 149°F (-20°C ~ 65°C)).

    Self-diagnosis
    If you don’t hear an audible warning sound or if the buzzer sounds intermittently when shifting the gear to the R (Reverse) position, this may indicate a malfunction in the rear parking assist s ...

    Around view monitoring system (AVM) (If equipped)
      This is the parking support system to show around circumstance when you park the vehicle in monitor. When you push the button in [ON] position, it is operated. To cancel the system, pu ...

    See also:

    Rear Door Inside Handle Repair procedures
    Replacement 1. Remove the rear door trim. (Refer to Rear Door - "Rear Door Trim") 2. Disconnect the rear door inside handle lamp connector (A). 3. After loosening the mounting screws, th ...

    Easy Access Function
    When exiting the vehicle, the steering wheel will move away from the driver and the seat will move rearward when the engine is turned off. When entering the vehicle, the steering wheel will move to ...

    Underdrive Brake Control Solenoid Valve(UD/B_VFS) Repair procedures
    Inspection 1. Turn ignition switch OFF. 2. Disconnect the E Module connector. 3. Measure resistance between sensor signal terminal and sensor ground terminal. 4. Check that the res ...

    Categories

    Hyundai Equus Manuals

    © 2011-2026 Copyright www.heqmanual.com