>
Hyundai Equus Manuals

Hyundai Equus: Front Seat Back Cover Repair procedures - Front Seat - Body (Interior and Exterior) - Hyundai Equus VI 2009-2026 Service ManualHyundai Equus: Front Seat Back Cover Repair procedures

Second generation VI (2009–2026) / Hyundai Equus VI 2009-2026 Service Manual / Body (Interior and Exterior) / Front Seat / Front Seat Back Cover Repair procedures

Replacement
   
•
Put on gloves to protect your hands.
   
•
When prying with a flat-tip screwdriver, wrap it with protective tape, and apply protective tape around the related parts, to prevent damage.
•
Use a plastic panel removal tool to remove interior trim pieces to protect from marring the surface.
•
Take care not to bend or scratch the trim and panels.
1.
Pull up the front seat headrest by pressing the power seat control switch.
2.
Pull up the front seat headrest (A).

3.
Remove the front seat assembly.
(Refer to Front Seat - "Front Seat Assembly")
4.
Remove the front seat rear shield outer cover.
(Refer to Front Seat - "Front Seat Shield Outer Cover")
5.
Disconnect the front seat under lamp connector (A).

6.
Using a screwdriver or remover, remove the rear monitor bezel (A).

7.
Press the clip (B) on top to remove the front seat back board (A).
   
•
Put in a flat-tip screwdriver into the gap on top of the front seat back and then push it to the front to remove the front seat back board.
•
Be careful not to damage the clip.

8.
Disconnect the air ventilation seat duct connector (A).
9.
After loosening the mounting screws, then remove the air ventilation seat duct (B).

10.
Remove the rear bumper joint connector mounting bolts (A).
11.
After loosening the mounting bolt, then remove the monitor (B).

12.
Pull out the protecter (A) by the front seat back frame.

13.
Pull up the front seat headrest guides (A).

14.
Remove the front seat back cover (A) from the front seat back frame.

15.
After removing the hog-ring clips on the front of seat back and remove the front seat back cover (A).

16.
Install in the reverse order of removal.
   
•
To prevent wrinkles, make sure the material is stretched evenly over the cover (B) before securing the hog-ring clips (A).
•
Replace the hog-ring clips with new ones using special tool (C) (09880-4F000).

    Front Seat Back Cover Components and Components Location
    Component Location 1. Front seat back cover ...

    Front Seat Cushion Cover Components and Components Location
    Component Location 1. Front seat cushion cover ...

    See also:

    If you have a flat tire while driving
    If a tire goes flat while you are driving: 1.Take your foot off the accelerator pedal and let the car slow down while driving straight ahead. Do not apply the brakes immediately or attempt to pull ...

    Seat Heater Switch Repair procedures
    Removal First Seat 1. Disconnect the negative (-) battery terminal. 2. Remove the floor console upper cover. (Refer to Body - "Floor Console Assembly") 3. Remove the seat heater switch a ...

    Tire terminology and definitions
    Air Pressure: The amount of air inside the tire pressing outward on the tire. Air pressure is expressed in pounds per square inch (psi) or kilopascal (kPa). Accessory Weight: This means the com ...

    Categories

    Hyundai Equus Manuals

    © 2011-2026 Copyright www.heqmanual.com