>
Hyundai Equus Manuals

Hyundai Equus: Rear Bumper Cover Repair procedures - Rear Bumper - Body (Interior and Exterior) - Hyundai Equus VI 2009-2026 Service ManualHyundai Equus: Rear Bumper Cover Repair procedures

Second generation VI (2009–2026) / Hyundai Equus VI 2009-2026 Service Manual / Body (Interior and Exterior) / Rear Bumper / Rear Bumper Cover Repair procedures

Replacement
   
•
Put on gloves to protect your hands.
   
•
When prying with a flat-tip screwdriver, wrap it with protective tape, and apply protective tape around the related parts, to prevent damage.
•
Use a plastic panel removal tool to remove interior trim pieces to protect from marring the surface.
•
Take care not to bend or scratch the trim and panels.
1.
Remove the rear transverse trim.
(Refer to "Trunk Trim")
2.
Remove the luggage covering complete.
(Refer to "Trunk Trim")
3.
Remove the luggage under cover.
(Refer to "Trunk Trim")
4.
Remove the luggage side trim.
(Refer to "Trunk Trim")
5.
Using a screwdriver or remover, remove the rear glass lower cover (A).

6.
After loosening the mounting nuts, then remove the rear window glass side cover (A).

7.
Disconnect the connector (A), and then loosen the rear combination lamp mounting nuts.

8.
Loosen the rear bumper lower mounting clips.

9.
Loosen the rear bumper lower mounting nuts.

10.
After loosening the rear bumper side's mounting screw and clips, then disconnect the side's.
   
•
Remove the rear bumper by pulling up the side of the rear bumper and then pull it out.
   
•
When you pull out the rear bumper, the side part of the rear bumper could be damaged by the projection.

11.
Loosen the rear bumper side upper bracket mounting nut.
   
•
Remove the rear bumper side upper bracket (A). Be careful not to damage the rear bumper side upper bracket because it is made of plastic.

12.
Loosen the rear bumper mounting bolt (A) inside of the trunk.

13.
Disconnect the rear bumper main connector (A).

14.
Install in the reverse order of removal.
   
•
Make sure the connector is connected properly.
•
Replace any damage clips.
    Rear Bumper Cover Components and Components Location
    Component Location 1. Rear bumper cover ...

    Rear Bumper Beam Assembly Components and Components Location
    Component Location 1. Rear bumper beam assembly ...

    See also:

    Clothes hanger
    To use the hanger, pull down the upper portion of hanger. CAUTION Do not hang heavy clothes, since those may damage the hook. ...

    Good braking practices
    WARNING Whenever leaving vehicle or parking, always set the parking brake as far as possible and fully engage the vehicle's transmission into the park position. Vehicles not fully engage ...

    Canister Close Valve (CCV) Description and Operation
    Description Canister Close Valve (CCV) is normally open and is installed on the canister ventilation line. It seals evaporative emission control system by shutting the canister from the atmosph ...

    Categories

    Hyundai Equus Manuals

    © 2011-2026 Copyright www.heqmanual.com