>
Inspection |
1. |
Turn ignition switch OFF. |
2. |
Disconnect the E Module connector. |
3. |
Measure resistance between sensor signal terminal and sensor ground terminal. |
4. |
Check that the resistance is within the specification. |
Rear Seat Cushion Cover Repair procedures
Replacement
[LH]
•
Put on gloves to protect your hands.
•
When prying with a flat-tip screwdriver, wrap it with
protective tape, and app ...
Accelerator Position Sensor (APS) Specifications
Specification
AcceleratorPositionOutput Voltage (V)APS1APS2C.T0.7 ~ 0.80.33 ~ 0.43W.O.T3.85 ~ 4.351.93 ~ 2.18
...
Memory Power Seat Switch Repair procedures
Removal
1.
Disconnect the negative (-) battery terminal.
2.
Remove the door trim (A) after loosening mounting screws.
(Refer to Body - "Front Door Trim")
3.
Remove the memory power seat c ...