>
Hyundai Equus: Rocking the vehicle
If it is necessary to rock the vehicle to free it from snow, sand, or mud, first turn the steering wheel right and left to clear the area around your front wheels. Then, shift back and forth between R (Reverse) and any forward gear in vehicles equipped with an automatic transmission. Do not race the engine, and spin the wheels as little as possible. If you are still stuck after a few tries, have the vehicle pulled out by a tow vehicle to avoid engine overheating and possible damage to the transmission.
CAUTION
Prolonged rocking may cause engine over-heating, transmission damage or failure, and tire damage.
WARNING - Spinning tires
Do not spin the wheels, especially at speeds more than 35 mph (56 km/h). Spinning the wheels at high speeds when the vehicle is stationary could cause a tire to overheat which could result in tire damage that may injure bystanders.
✽ NOTICE
The ESC system should be turned OFF prior to rocking the vehicle.
WARNING
If your vehicle becomes stuck in snow, mud, sand, etc., then you may attempt to rock the vehicle free by moving it forward and backward. Do not attempt this procedure if people or objects are anywhere near the vehicle. During the rocking operation the vehicle may suddenly move forward or backward as it becomes unstuck, causing injury or damage to nearby people or objects.
Hazardous driving conditions
Smooth corneringFuel Filler Door Release Actuator Repair procedures
Inspection
1.
Remove the trunk room left side trim.
2.
Open the fuel filler door and remove the housing.
(Refer to the BD group - "Exterior")
Do not reuse the fuel fill ...
Lumbar Support Unit Repair procedures
Removal
1.
Disconnect the negative (-) battery terminal.
2.
Remove the rear seat back.
(Refer to Body - "Rear Seat Back Cover")
3.
Remove the bladder & ECU/ valve assembly (A) after l ...
Oil Pressure Switch Repair procedures
Inspection
1.
Check the continuity between the terminal and the body with an ohmmeter.
If there is no continuity, replace the oil pressure switch.
2.
Check the continuity between the terminal ...