>

Hyundai Equus: Rear Seat Belt Retractor Repair procedures - Rear Seat Belt - Body (Interior and Exterior) - Hyundai Equus VI 2009-2026 Service ManualHyundai Equus: Rear Seat Belt Retractor Repair procedures

Replacement
   
When installing the belt, make sure not to damage the retractor.
1.
Remove the rear package tray trim.
(Refer to Interior Trim - "Rear Package Tray Trim")
2.
After loosening the mounting bolt, then remove the rear seat belt retractor (A).

Tightening torque :
39.2 ~ 53.9 N.m (4.0 ~ 5.5 kgf.m, 28.8 ~ 39.8 lb-ft)

3.
After loosening the retractor (A) mounting bolt, remove the rear seat belt (B).

Tightening torque :
39.2 ~ 53.9 N.m (4.0 ~ 5.5 kgf.m, 28.8 ~ 39.8 lb-ft)

4.
Install in the reverse order of removal.
   
Make sure the connector is plugged in properly.
Replace any damaged clips.
    Rear Seat Belt Retractor Components and Components Location
    Component Location 1. Rear seat belt retractor ...

    Rear Center Seat Belt Retractor Components and Components Location
    Component Location 1. Rear center seat belt retractor ...

    See also:

    Evaporator Temperature Sensor Repair procedures
    Inspection 1. Turn the ignition switch OFF. 2. Disconnect the evaporator temperature sensor connector. 3. Measure the resistance between terminal “+” and “-” of the evaporator temp ...

    Temperature Control Actuator Repair procedures
    Inspection 1. Turn the ignition switch OFF. 2. Disconnect the temperature control actuator connector. 3. Verify that the temperature control actuator operates to the warm (Driver's side) ...

    Start-Up
    You can start the engine without inserting the key. For detailed information refer to the Engine Start/Stop Button in section 5. CAUTION To prevent damaging the Smart Key : Keep the Smart Key ...

    Categories

    Hyundai Equus Manuals

    2011-2026 Copyright www.heqmanual.com