>
Replacement |
|
|
1. |
Detach the clip, then remove the frame inner cover (A). |
2. |
Using a screwdriver or remover, remove the rear door pull handle cap (A). |
3. |
Remove the inside handle cover (A). |
4. |
Loosen the door trim (B) mounting screws, Release the clips that hold the door trim. |
5. |
Push the hook, then remove the inside handle cable cage (A). |
6. |
Remove the rear door inside handle cage (A). |
7. |
Disconnect the power window connector (A), then remove the door trim. |
8. |
Install in the reverse order of removal.
|
PGS Unit (Back & Blinde Unit) Components and Components Location
Components
...
Sedan Front Body
Front body A
Roof panel front cornerFront pillar outer cornerHood hinge mounting hole (O13)Shockabsorber mounting hole (O24)Front end module mounting hole (O9)Cowl top cover mounting hole (O7)
F ...
ECU Repair procedures
Removal
•
Avoid suffering excessive impact.
•
Do not entering the water into pin inside.
•
Do not pile up the parts.
•
Take care not to damage the pin of ...