>
Inspection |
1. |
Remove the front door quadrant inner cover. Take care not to damage fixing clips.
(Refer to Body - "Front Door") |
2. |
Disconnect the power door mirror connector from the harness. |
3. |
Apply battery voltage to each terminal as shown in the table and verify that the mirror operates properly.
Memory Mirror
Mirror Heater
Puddle Lamp
Turn Signal Lamp
BSD Warning Lamp
ECM Function
Folding Mirror |
Trunk Lid Assembly Repair procedures
Replacement
•
Wear gloves to protect hands from injury.
•
When removing and installing the trunk lid, an assistant is necessary.
1.
Rem ...
Receiver-Drier Repair procedures
Replacement
1.
Remove the condenser.
2.
Remove the cap (B) on the bottom of the condenser with a L wrench (A).
Tightening torque :
2.7 ~ 3.1 N.m (0.28 ~ 0.32 kgf.m, 2.0 ~ 2.3 lb-ft)
...
Air Quality Sensor (AQS) Description and Operation
Desciption
The Air Quality Sensor (AQS) is located at the center support
in front of the engine radiator. It detects hazardous elements in
ambient air providing output signal to the control.
A ...