>
Remove |
1. |
Turn ignition switch OFF and disconnect the negative (-) battery cable. |
2. |
Remove the IDB cover (A). |
3. |
Disconnect the IDB Connector (A). |
4. |
Remove the mounting bolts (B), and then remove the IDB (C). |
Installation |
1. |
Install in the reverse order of removal.
|
Rear Shock Absorber Repair procedures
Removal
1.
Remove the rear wheel and tire (A) from rear hub .
Tightening torque:
88.3 ~ 107.9 N.m (9.0 ~ 11.0 kgf.m, 65.1 ~ 79.6 lb-ft)
•
Be careful not to damage t ...
Cylinder Block Repair procedures
Disassembly
Engine removal is required for this procedure.
•
Use fender covers to avoid damaging painted surfaces.
•
To avoid damage, unplug the wiring connectors ca ...
Information Mode
Service Interval
This mode shows the service interval (mileage and days).
❈ For the setting of the service interval, refer to "User Settings Mode" of
the LCD display.
Service in
...