>

Hyundai Equus: Hazard warning flasher - Road warning - What to do in an emergency - Hyundai Equus 2009-2020 Owners ManualHyundai Equus: Hazard warning flasher

The hazard warning flasher serves as a warning to other drivers to exercise extreme


The hazard warning flasher serves as a warning to other drivers to exercise extreme caution when approaching, overtaking, or passing your vehicle.

It should be used whenever emergency repairs are being made or when the vehicle is stopped near the edge of a roadway.

Depress the flasher switch with the ignition switch in any position. The flasher switch is located in the center console switch panel. All turn signal lights will flash simultaneously.

  • The hazard warning flasher operates whether your vehicle is running or not.
  • The turn signals do not work when the hazard flasher is on.
  • Care must be taken when using the hazard warning flasher while the vehicle is being towed.
    Road warning
    ...

    Emergency while driving
    ...

    See also:

    Heated Oxygen Sensor (HO2S) Troubleshooting
    Signal Waveform Fig.1) The signal waveforms of front HO2S(the upper) and heater(the lower) at idle Fig.2) The signal waveforms of rear HO2S(the upper) and heater(the lower) at idle Fig.3) Typical ...

    Erasing HomeLink buttons
    Individual buttons cannot be erased. However, to erase all three programmed buttons: 1. Press and hold the two outer HomeLink buttons until the indicator light begins to flash after 10 seconds. 2 ...

    Crash Pad Under Cover Repair procedures
    Replacement [LH]     Put on gloves to protect your hands.     When prying with a flat-tip screwdriver, wrap it with protective tape, and apply ...

    Categories

    Hyundai Equus Manuals

    2011-2020 Copyright www.heqmanual.com