>
Replacement |
1. |
Turn the ignition switch OFF and disconnect the negative (-) battery cable. |
2. |
Remove the service cover (A). |
3. |
Disconnect the canister close valve connector (A). |
4. |
Disconnect the vapor hose (B) from the canister. |
5. |
Remove the installation bolt (C). |
6. |
Disconnect the vapor hose (A) from the connector assembly (B). |
7. |
Remove the fuel tank air filter after removing the connector assembly installation bolts (C). |
8. |
Install a new fuel tank assembly.
|
Over Pressure Valve (OPV) Repair procedures
Removal
1.
Turn the ignition switch OFF and disconnect the battery negative (-) cable.
2.
Release the residual pressure in fuel line.
(Refer to Fuel Delivery System -"Release Residual Pressu ...
Indicator Lights
Electronic Stability Control (ESC) Indicator Light
This indicator light illuminates:
Once you set the ignition switch or Engine Start/Stop Button to the ON position.It
illuminates for approx ...
Cylinder Block Components and Components Location
Components
1. Cylinder block bank cover2. Cylinder block bank cover gasket3. Cylinder block rear cover4. Cylinder block rear cover gasket5. Separator6. Drain plug7. O-ring8. Piston oil jet9. Chec ...