>
Inspection |
1. |
Turn ignition switch OFF and disconnect the negative (-) battery cable |
2. |
Remove the crash pad side cover. |
3. |
Remove the lower panel.
(Refer to Body - "Crash Pad") |
4. |
Remove the lower crash pad switch assembly by using the scraper and then disconnect the connectors. |
5. |
Check the continuity between the switch terminals as the ESP OFF switch is engaged. |
Rail Pressure Sensor (RPS) Description and Operation
Description
Rail Pressure Sensor (RPS) is installed on the delivery pipe
and measures the instantaneous fuel pressure in the delivery pipe. The
sensing element (Semiconductor element) built in ...
Injector Description and Operation
Description
Based on information from various sensors, the ECM can
calculate the fuel amount to be injected. The fuel injector is a
solenoid-operated valve and the fuel injection amount is cont ...
Tire Repair procedures
Tire Wear
1.
Measure the tread depth of the tires.
Tread depth [limit] : 1.6 mm (0.063 in)
2.
If the remaining tread (A) depth is less than the limit, replace the tire.
  ...