>
Hyundai Equus Manuals

Hyundai Equus: Repair procedures - Fuel Filler Door - Body (Interior and Exterior) - Hyundai Equus VI 2009-2026 Service ManualHyundai Equus: Repair procedures

Second generation VI (2009–2026) / Hyundai Equus VI 2009-2026 Service Manual / Body (Interior and Exterior) / Fuel Filler Door / Repair procedures

Replacement
   
•
Put on gloves to protect your hands.
   
•
When prying with a flat-tip screwdriver, wrap it with protective tape, and apply protective tape around the related parts, to prevent damage.
•
Take care not to scratch the body surface.
1.
Open the fuel filler door cap (A).

2.
Remove the fuel filler door mounting pin (A) by turning it counter clock-wise.

3.
After loosening the mounting clips, then remove the fuel filler door housing (A).
   
•
Pull out from inside of the packing part (B) When removing the fuel filler door housing.

4.
Using a clip remove or remover, remove the fuel fill door (A).

5.
Install in the reverse order of removal.
   
•
Make sure the fuel filler door locks/unlocks and opens/closes properly.
•
Replace any damaged clips.
    Components and Components Location
    Component Location 1. Fuel filler door ...

    Front Door
    ...

    See also:

    Solenoid Valve Description and Operation
    Description Four air spring solenoid valves (‘-’ control) and one ambient solenoid valve are embedded inside this solenoid valve block as shown in the circuit diagram below. When connecting ...

    Blower Unit Components and Components Location
    Component Location Components 1. Intake Duct Case2. Intake Duct Case (A)3. Intake Door4. Intake Actuator5. Seal6. Blower Upper Case7. Blower Lower Case8. Seal9. Climate Control Air Filter Cover1 ...

    Repair procedures
    EOL Input Description When shift shock is occurred or parts related with the transmission are replaced, EOL should be performed. In the following case, EOL is required. • Transmission ass ...

    Categories

    Hyundai Equus Manuals

    © 2011-2026 Copyright www.heqmanual.com