>
Hyundai Equus Manuals

Hyundai Equus: Trunk Lid Trim Repair procedures - Trunk Lid - Body (Interior and Exterior) - Hyundai Equus VI 2009-2026 Service ManualHyundai Equus: Trunk Lid Trim Repair procedures

Second generation VI (2009–2026) / Hyundai Equus VI 2009-2026 Service Manual / Body (Interior and Exterior) / Trunk Lid / Trunk Lid Trim Repair procedures

Replacement
   
•
Put on gloves to protect your hands.
   
•
When prying with a flat-tip screwdriver, wrap it with protective tape, and apply protective tape around the related parts, to prevent damage.
•
Take care not to scratch the body surface.
1.
Detach the clips, then remove the trunk lid side cover (A).

2.
Using a screwdriver, remove the trunk lid switch (A), and disconnect the connector.

3.
Detach the clip, then remove the trunk lid cover A).

4.
Remove the trunk lid overslam bumpers (A).
5.
After loosening the mounting screw and clips, then remove the trunk lid trim (B).

6.
Install in the reverse order of removal.
   
•
Replace any damaged clips.
    Trunk Lid Trim Components and Components Location
    Component Location 1. Trunk lid trim ...

    Trunk Lid Latch Components and Components Location
    Component Location 1. Trunk lid latch ...

    See also:

    Driver Door Module (DDM) Components and Components Location
    Component ...

    Intake Air Temperature Sensor (IATS) Schematic Diagrams
    Circuit Diagram ...

    Damper Clutch Control Solenoid Valve Repair procedures
    Inspection 1. Turn ignition switch OFF. 2. Disconnect the E Module connector. 3. Measure resistance between sensor signal terminal and sensor ground terminal. 4. Check that the resi ...

    Categories

    Hyundai Equus Manuals

    © 2011-2026 Copyright www.heqmanual.com