>

Hyundai Equus: Trunk Lid Assembly Repair procedures - Trunk Lid - Body (Interior and Exterior) - Hyundai Equus VI 2009-2026 Service ManualHyundai Equus: Trunk Lid Assembly Repair procedures

Replacement
   
•
Wear gloves to protect hands from injury.
   
•
When removing and installing the trunk lid, an assistant is necessary.
1.
Remove the trunk lid trim.
(Refer to Trunk Lid - "Trunk Lid Trim")
2.
Disconnect the connectors and trunk lid wiring harness (A).
3.
After loosening the mounting bolts, then remove the trunk lid assembly (B).

Tightening torque :
21.6 ~ 26.5 N.m (2.2 ~ 2.7 kgf.m, 15.9 ~ 19.5 lb-ft)

4.
Install in the reverse order of removal.
   
•
Make sure the trunk lid locks/unlocks and opens/closes properly.
•
Adjust the trunk lid alignment.
•
Make sure the connectors are connected in properly.
•
Replace any damaged clips.
    Trunk Lid Assembly Components and Components Location
    Component Location 1. Trunk lid assembly ...

    Trunk Lid Trim Components and Components Location
    Component Location 1. Trunk lid trim ...

    See also:

    Tilting the Sunroof
    To tilt the sunroof open: Push the sunroof control lever upward to the second detent position. To stop the sunroof tilting at any point, operate the control lever. To close the sunroof: Pull ...

    Driving your vehicle
    WARNING - ENGINE EXHAUST CAN BE DANGEROUS! Engine exhaust fumes can be extremely dangerous. If, at any time, you smell exhaust fumes inside the vehicle, open the windows immediately. Do not inh ...

    Loss of a Smart Key
    A maximum of three Smart Keys including Card Type Smart Key can be registered to a single vehicle. If you happen to lose your Smart Key, you should immediately take the vehicle and remaining key t ...

    Categories

    Hyundai Equus Manuals

    © 2011-2026 Copyright www.heqmanual.com