>
Hyundai Equus Manuals

Hyundai Equus: Hood Latch Repair procedures - Hood - Body (Interior and Exterior) - Hyundai Equus VI 2009-2026 Service ManualHyundai Equus: Hood Latch Repair procedures

Second generation VI (2009–2026) / Hyundai Equus VI 2009-2026 Service Manual / Body (Interior and Exterior) / Hood / Hood Latch Repair procedures

Replacement
1.
Remove the hood latch cover (A) mounting clip.
(Refer to Engine Mechanical System - "Active Air Flap(AAF)")
2.
Loosen the hood latch (B) mounting bolts.
Tightening torque :
7.8 ~ 11.8 N.m (0.8 ~ 1.2 kgf.m, 5.8 ~ 8.7 lb-ft)

3.
Disconnect the connector (A), then remove the wiring mounting clips.

4.
Installation is the reverse of removal.
   
•
Make sure the hood latch release cable is connected properly.
•
Make sure the hood locks/unlocks and opens/closes properly.
•
Adjust the latch alignment.
    Hood Latch Components and Components Location
    Component Location 1. Hood latch assembly ...

    Trunk Lid
    ...

    See also:

    27 Brake Control Solenoid Valve Repair procedures
    Inspection 1. Turn ignition switch OFF. 2. Disconnect the E Module connector. 3. Measure resistance between sensor signal terminal and sensor ground terminal. 4. Check that the res ...

    Lane departure warning system (LDWS) (If equipped)
    This system detects the lane with the sensor at the front windshield and warns you when your vehicle leaves the lane. WARNING The LDWS does not make the vehicle change lanes. It is the driver ...

    Description and Operation
    Description The BSD (Blind Spot Detection) system uses a radar sensor to alert the driver while driving. It senses the rear side territory of the vehicle and provides information to the driver. - ...

    Categories

    Hyundai Equus Manuals

    © 2011-2026 Copyright www.heqmanual.com