>
Hyundai Equus Manuals

Hyundai Equus: Repair procedures - Fender - Body (Interior and Exterior) - Hyundai Equus VI 2009-2025 Service ManualHyundai Equus: Repair procedures

Second generation VI (2009–2025) / Hyundai Equus VI 2009-2025 Service Manual / Body (Interior and Exterior) / Fender / Repair procedures

Replacement
   
•
Be careful not to damage the fender and body.
   
•
When removing the clips, use a clip remover.
1.
Loosen the front wheel guard mounting clip and screws.

2.
Loosen the mounting screws and clips, remove the side sill garnish.
3.
Loosen the bumper side mounting screw, disconnect the side's bumper (A).

4.
Loosen the mounting screws, remove the front bumper side mounting bracket.
5.
Loosen the fender mounting bolts, remove the fender (A).

6.
Install in the reverse order of removal.
   
•
Replace any damaged clips.
    Components and Components Location
    Component Location 1. Fender assembly ...

    Hood
    ...

    See also:

    Transmission Control Module (TCM) Schematic Diagrams
    1. TCM Connector and Terminal Function 2. TCM Terminal Function Connector PinDescriptionPinDescription1Battery power48-2Battery power49-3Power(IG 1)5027 Brake control solenoid valve4Ground51-5G ...

    Repair procedures
    On-vehicle Inspection Inspect ignition coil assembly and Perform spark test 1. Check for DTCs.     • If a DTC is present, perform troubleshooting in accordance with the ...

    Fuel Pump Control Module (FPCM) Repair procedures
    Inspection 1. Connect the GDS on the Data Link Connector (DLC). 2. Check the output voltage of fuel pressure sensor (FPS). Specification: Refer to “Specification” ...

    Categories

    Hyundai Equus Manuals

    2011-2025 Copyright www.heqmanual.com