Hyundai Equus: Standard programming
Second generation VI (2009–2026) / Hyundai Equus 2009-2026 Owners Manual / Features of your vehicle / Mirrors / Standard programming
To train most devices, follow these instructions:
1. For first-time programming, press and hold the two outside buttons, HomeLink®
Channel 1 and Channel 3 Buttons, until the indicator light begins to flash (after
20 seconds). Release both buttons. Do not hold the buttons for longer than 30 seconds.
2. Position the end of your hand-held transmitter 1-3 inches (2-8 cm) away from
the HomeLink® buttons while keeping the indicator light in view.
3. Simultaneously press and hold both the HomeLink® and handheld transmitter button.
DO NOT release the buttons until step 4 has been completed.
4. While continuing to hold the buttons the red Indicator Status LED will flash
slowly and then rapidly after HomeLink® successfully trains to the frequency signal
from the hand-held transmitter. Release both buttons.
5. Press and hold the just-trained HomeLink® button and observe the red Status Indicator
LED. If the indicator light stays on constantly, programming is complete and your
device should activate when the HomeLink® button is pressed and released.
6. To program the remaining two HomeLink® buttons, follow steps 2 through 5.
Compass function
The Compass can be turned ON and OFF and will remember the last state when the
ignition is cycled. To turn the display feature ON/OFF:
1. Press and release the button
to turn the display feature ...
Rolling code programming
Rolling code devices which are "code-protected" and manufactured after 1996 may
be determined by the following:
Reference the device owner's manual for verification.
The handheld ...
See also:
Specifications
Specification
Air Conditioner
ItemSpecificationCompressorType7VSX18Oil type & CapacityPAG 120± 10cc (4.1±0.3oz.)Pulley typeAround rubber damperDisplacement180cc/revCondenserHeat rejection18, ...
Oil Pump Repair procedures
Removal
1.
Remove the sub frame.
(Refer to SS group)
2.
Drain engine oil.
(1)
Remove the oil filler cap.
(2)
After lifting the car, remove the oil drain plug and drain oil into a conta ...
Rear Glass Defogger Switch Repair procedures
Removal
1.
Disconnect the negative (-) battery terminal.
2.
Using a screwdriver or plastic panel remover, remove the cluster fascia upper panel (A).
3.
Using a screwdriver or plastic panel ...
Categories
Hyundai Equus Manuals
