>
Removal |
1. |
Turn ignition switch off and disconnect the battery (-) cable from the battery |
2. |
Remove the driver side crash pad side cover.
(Refer to Body - "Crash Pad") |
3. |
Remove the crash pad lower panel.
(Refer to Body - "Crash Pad") |
4. |
Remove the EPB switch after removing 4 screws from the crash pad lower panel. |
Inspection |
1. |
Measure resistance between EPB switch terminals as below. |
1. |
Measure resistance between Auto Hold switch terminals as below. |
Installation |
1. |
Install EPB switch assembly. |
2. |
Connect the crash pad switch assembly connector to EPB switch. |
3. |
Install the crash pad lower panel.
(Refer to Body - "Crash Pad") |
4. |
Install the driver side crash pad side cover.
(Refer to Body - "Crash Pad") |
Rocking the vehicle
If it is necessary to rock the vehicle to free it from snow, sand, or mud, first
turn the steering wheel right and left to clear the area around your front wheels.
Then, shift back and forth betwe ...
Low aspect ratio tire (if equipped)
Low aspect ratio tires, whose aspect ratio is lower than 50, are provided for
sporty looks.
Because the low aspect ratio tires are optimized for handling and braking, it
may be more uncomfortable ...
Blower Motor Repair procedures
Inspection
1.
Connect the battery voltage and check the blower motor rotation.
2.
If the blower motor does not operate well, substitute with a known-good blower motor and check for proper oper ...