>
Hyundai Equus Manuals

Hyundai Equus: Pre-active Seat Belt (PSB) Components and Components Location - Seat Belt Pretensioner - Restraint - Hyundai Equus VI 2009-2026 Service ManualHyundai Equus: Pre-active Seat Belt (PSB) Components and Components Location

Second generation VI (2009–2026) / Hyundai Equus VI 2009-2026 Service Manual / Restraint / Seat Belt Pretensioner / Pre-active Seat Belt (PSB) Components and Components Location

Components

Main Function
1.
Full Retraction
Maintains a more safe posture by strongly rewinding the seat belt right before a crash.
[Operation Condition]
A.
When a frontal crash is detected by the radar
B.
When sudden braking
C.
When vehicle control function is disabled
2.
Dynamic Support
Stabilizes the driver from foward and centrifugal force by rewinding the seat belt during sudden braking or turning.
[Operation Condition]
A.
When sudden braking (Forward force)
B.
When sudden turning (Centrifugal force)
C.
When sliding in icy road
3.
Haptic Warning
Warns the driver with seat belt vibration when the vehicle gets out of its lane or any other dangerous situation occurs.
[Operation Condition]
A.
When a vehicle ahead is detected very near by the radar
B.
When the vehicle leaving the lane is detected by LDWS
4.
Slack Removal
If the seat belt isn’t completely fastened, it will not work normally in a vehicle crash situation. In this case, this system completely fastens the seat belt by winding the belt slightly when the vehicle speed reaches 40kph.
5.
Seat Belt Parking
After the seat belt is released, it returns the seat belt to its original position in 3 seconds by retracting the belt.
However, this function does not work when the belt has already returned to its original position.
Pre-active Seat Belt (PSB) Warning Lamp
The Pre-active Seat Belt (PSB) warning lamp located on the cluster is to inform you that there is a problem with the system.
When the ignition switch is turned ON, it is normal if the lamp is turned on for 3 seconds. However, there may be a problem if the following condtions occurs.
1)
The lamp is turned on continuously when the ignition switch is in the ON position.
2)
The lamp turns on while driving.

    Pre-active Seat Belt (PSB) Description and Operation
    Description Pre-active Seat Belt (PSB) guarantees initial restraint performance by winding the seat belt right before a crash or dangerous condition and enhances the effects of the seat belt pr ...

    Pre-active Seat Belt (PSB) Schematic Diagrams
    Circuit Diagram ...

    See also:

    Blower Unit Components and Components Location
    Component Location Components 1. Intake Duct Case2. Intake Duct Case (A)3. Intake Door4. Intake Actuator5. Seal6. Blower Upper Case7. Blower Lower Case8. Seal9. Climate Control Air Filter Cover1 ...

    Emergency Fastening Device (EFD) Repair procedures
    Removal 1. Disconnect the battery negative cable, and wait for at least three minutes before beginning work. 2. Remove the front seat assembly. (Refer to Body - "Front Seat Assembly") 3. ...

    Cleaning the interior  window glass
    If the interior glass surfaces of the vehicle become fogged (that is, covered with an oily, greasy or waxy film), they should be cleaned with glass cleaner. Follow the directions on the glass clea ...

    Categories

    Hyundai Equus Manuals

    © 2011-2026 Copyright www.heqmanual.com