>
Hyundai Equus: Seat Belt Buckle Switch (BS) Repair procedures
| Removal |
| 1. |
Disconnect the battery negative cable, and wait for at least three minutes before beginning work. |
| 2. |
Remove the front seat assembly.
(Refer to Body - "Front Seat Assembly") |
| 3. |
Remove the seat belt buckle switch.
(Refer to Body - "Front Seat Belt Buckle")
|
| Installation |
Be sure to install the harness wires so they will not pinch or interfere with other parts.
|
| 1. |
Turn the ignition switch OFF. |
| 2. |
Disconnect the battery negative cable, and wait for at least three minutes before beginning work. |
| 3. |
Install the seat belt buckle switch.
(Refer to Body - "Front Seat Belt Buckle") |
| 4. |
Install the front seat assembly.
(Refer to Body - "Front Seat Assembly") |
| 5. |
Reconnect the battery negative cable. |
| 6. |
After installing the seat belt buckle switch, confirm proper system operation:
Turn the ignition switch ON; the SRS indicator should turn on for about six seconds and then go off. |
Schematic DiagramsRemoving and storing the spare tire
Turn the tire hold-down wing bolt counterclockwise.
Store the tire in the reverse order of removal.
To prevent the spare tire and tools from “rattling” while the vehicle is in motion,
stor ...
Rear Driveshaft (VL-VL TYPE) Repair procedures
Replacement
1.
Loosen the wheel nuts slightly.
Raise the vehicle, and make sure it is securely supported.
2.
Remove the rear wheel and tire (A) from rear hub.
Be carefu ...
Puddle lamp
When all the doors (and trunk) are locked and closed, the puddle lamp will come
on for about 15 seconds if any of the below is performed.
- When the door unlock button is pressed on the smart k ...