Hyundai Equus: Troubleshooting
| Troubleshooting |
| Symptom | Probable cause | Remedy |
| Excessive play in steering | Loose yoke plug | Retighten |
| Loose steering gear mounting bolts | Retighten |
| Loose or worn tie rod end | Retighten or replace as necessary |
| Steering wheel operation is not smooth (Insufficient power assist) | V-belt slippage | Readjust |
| Damaged V-belt | Replace |
| Low fluid level | Replenish |
| Air in the fluid | Bleed air |
| Twisted or damaged hoses | Correct the routing or replace |
| Insufficient motor pressure | Repair or replace the motor |
| Sticky flow control valve | Replace |
| Excessive internal motor leakage | Replace the damaged parts |
| Excessive oil leaks from rack and pinion in gear box | Replace |
| Distorted or damaged gear box or valve body seals | Replace |
| Steering wheel does not return properly | Excessive turning resistance of tierod end | Replace |
| Yoke plug excessively tight | Adjust |
| Tie rod and/or ball joint cannot turn smoothly | Replace |
| Loose mounting of gear box mounting bracket Worn steering shaft joint and/or | Retighten |
| Worn steering shaft joint and/or body grommet | Correct or replace |
| Distorted rack | Replace |
| Damaged pinion bearing | Replace |
| Twisted or damaged hoses | Reposition or replace |
| Damaged oil pressure control valve | Replace |
| Damaged motor input shaft bearing | Replace |
| Noise | Hissing Noise in Steering Gear There is some noise with all power steering systems. One of the most common is a hissing sound when the steering wheel is turned and the car is not moving. This noise will be most evident when turning the wheel while the brakes are being applied. There is no relationship between this noise and steering performance. Do not replace the valve unless the "hissing" noise becomes extreme. A replaced valve will also make a slight noise, and is not always a solution for the condition. |
| Rattling or chucking noise in the rack and pinion | Interference with hoses from vehicle body | Reposition |
| Loose gear box bracket | Retighten |
| Loose tie rod end and/or ball joint | Retighten |
| Worn tie rod and/or ball joint | Replace |
| Noise in the motor | Low fluid level | Replenish |
| Air in the fluid | Bleed air |
| Loose motor mounting bolts | Retighten |
Special Service Tools
Special Service Tools
Tool (Number and Name)IllustrationUse09561-11001Steering wheel pullerRemoval of steering wheel
...
Repair procedures
Service Adjustment Procedure
Steering Wheel Play Inspection
1.
Turn the steering wheel so that the front wheels can face straight ahead.
2.
Measure the distance that the steering wheel can be ...
See also:
Timing Chain Components and Components Location
Components
1. Timing chain upper cover2. Timing chain upper cover gasket3. CVVT assembly4. Camshaft5. Timing chain lower cover6. Timing chain lower cover gasket(#1)7. Timing chain lower cover gas ...
Rain Sensor Repair procedures
Removal
The dust or foreign substance on the rain sensor have a bad
effect upon the rain sensor capability,so protect the sensor surface
with protection cover until instal ...
Trailing Arm Repair procedures
Removal
1.
Remove the rear wheel and tire (A) from rear hub .
Tightening torque:
88.3 ~ 107.9 N.m (9.0 ~ 11.0 kgf.m, 65.1 ~ 79.6 lb-ft)
•
Be careful not to damage ...
Categories
Hyundai Equus Manuals
© 2011-2026 Copyright www.heqmanual.com