| 1. |
Removal the front wheel & tire.
Tightening torque :
90.0 ~ 110.0 N.m(9.0 ~ 11.0 kgf.m, 65.0 ~ 80.0 lb-ft)
|
|
| 2. |
Disconnect the stabilizer link (A) from the front strut assembly by loosening the nut.
Tightening torque :
100.0 ~ 120.0 N.m(10.0 ~ 12.0 kgf.m, 72.0 ~ 87.0 lb-ft)
|

|
| 3. |
Disconnect the stabilizer bar (A) from the front sub frame by loosening the bolt.
Tightening torque :
45.0 ~ 55.0 N.m (4.5 ~ 5.5 kgf.m, 33.0 ~ 40.0 lb-ft)
|

|
| 4. |
Installation is the reverse of removal. |
| 1. |
Remove the rear wheel & tire.
Tightening torque :
90.0 ~ 110.0 N.m(9.0 ~ 11.0 kgf.m, 65.0 ~ 80.0 lb-ft)
|
|
| 2. |
Disconnect the rear stabilizer link (A) from the rear lower arm by loosening the nut.
Tightening torque :
50.0 ~ 65.0 N.m(5.0 ~ 65 kgf.m, 36.0 ~ 47.0 lb-ft)
|

|
| 3. |
Loosen the mounting bolt and then remove the stabilizer bar (A).
Tightening torque :
50.0 ~ 65.0 N.m(5.0 ~ 6.5 kgf.m, 36.0 ~ 47.0 lb-ft)
|

|
| 4. |
Installation is the reverse of removal. |
| 1. |
Check the bushing for wear and deterioration. |
| 2. |
Check the ball joint for rotating torque. |
Removal
[Front Lower Arm]
Replacement the lateral arm
1.
Removal the front wheel & tire.
Tightening torque :
90.0 ~ 110.0 N.m(9.0 ~ 11.0 kgf.m, 65.0 ~ 80.0 lb-ft)
2.
Disconnect ...
Removal
[Front Upper arm]
1.
Removal the front wheel & tire.
Tightening torque :
90.0 ~ 110.0 N.m(9.0 ~ 11.0 kgf.m, 65.0 ~ 80.0 lb-ft)
2.
Removal the air strut assembly.
(Refer ...
See also:
Auto Defogging Actuator Repair procedures
Inspection
1.
Turn the ignition switch OFF.
2.
Disconnect the auto defogging connector.
3.
Verify that the auto defogging actuator operates to the open
position when connecting 12V to ...
Sunroof Glass Components and Components Location
Component Location
1. Sunroof glass
...
Troubleshooting
Basic Troubleshooting
Basic Troubleshooting Guide
Customer Problem Analysis Sheet
Basic Inspection Procedure
Measuring Condition of Electronic Parts' Resistance
The measured resistance at high ...