>
Hyundai Equus Manuals

Hyundai Equus: Front Stabilizer Bar Repair procedures - Front Suspension System - Suspension System - Hyundai Equus VI 2009-2026 Service ManualHyundai Equus: Front Stabilizer Bar Repair procedures

Second generation VI (2009–2026) / Hyundai Equus VI 2009-2026 Service Manual / Suspension System / Front Suspension System / Front Stabilizer Bar Repair procedures

Replacement
1.
Removal the front wheel & tire.
Tightening torque :
90.0 ~ 110.0 N.m(9.0 ~ 11.0 kgf.m, 65.0 ~ 80.0 lb-ft)
2.
Disconnect the stabilizer link (A) from the front strut assembly by loosening the nut.
Tightening torque :
100.0 ~ 120.0 N.m(10.0 ~ 12.0 kgf.m, 72.0 ~ 87.0 lb-ft)

3.
Disconnect the stabilizer bar (A) from the front sub frame by loosening the bolt.
Tightening torque :
50.0 ~ 65.0 N.m(5.0 ~ 6.5 kgf.m, 36.0 ~ 47.0 lb-ft)

4.
Installation is the reverse of removal.
Inspection
1.
Check the bushing for wear and deterioration.
2.
Check the ball joint for rotating torque.
    Front Lower Arm Repair procedures
    Removal Remove the lateral arm. 1. Remove the front wheel and tire (A) from front hub . Tightening torque: 88.3 ~ 107.9 N.m (9.0 ~ 11.0 kgf.m, 65.1 ~ 79.6 lb-ft)     • ...

    Rear Suspension System
    ...

    See also:

    Rear Right Door Module (RRDM) Components and Components Location
    Component ...

    Mode Control Actuator Repair procedures
    Inspection 1. Turn the ignition switch OFF. 2. Disconnect the mode control actuator connector. 3. Verify that the mode control actuator operates to the defrost mode when connecting 12V to ...

    Good braking practices
    WARNING Whenever leaving vehicle or parking, always set the parking brake as far as possible and fully engage the vehicle's transmission into the park position. Vehicles not fully engage ...

    Categories

    Hyundai Equus Manuals

    © 2011-2026 Copyright www.heqmanual.com