>
Hyundai Equus: Recalling Position into Memory
1. Check that the shift lever is in P (Park) and the Engine Start/Stop Button
is in the ON position.
2. Press the desired memory button (1 or 2). The system will beep once, then the
driver's seat, outside rearview mirrors, steering wheel and HUD (Head-Up Display)
height will automatically adjust to the stored positions.
Pressing one of the control buttons for the driver’s seat, the outside rearview mirrors, or the steering wheel while the system is recalling the stored positions will cause the movement for that component to stop and move in the direction that the control button is pressed. Other components will continue to the recalled position.
WARNING
Use caution when recalling adjustment memory while sitting in the vehicle. Push the seat position control knob to the desired position immediately if the seat moves too far in any direction.
Storing Position into Memory
Easy Access FunctionFront Door Trim Components and Components Location
Component Location
1. Front door trim
...
Battery Sensor Repair procedures
Removal
1.
Disconnect the battery negative (-) cable.
2.
Disconnect the battery sensor connector (A).
3.
Remove the battery negative (-) cable after removing the bolts (B).
Installation
...
Driving off-road
Drive carefully off-road because your vehicle may be damaged by rocks or roots
of trees. Become familiar with the off-road conditions where you are going to drive
before you begin driving. ...