>

Hyundai Equus: Front Upper Arm Repair procedures - Front Suspension System - Suspension System - Hyundai Equus VI 2009-2026 Service ManualHyundai Equus: Front Upper Arm Repair procedures

Removal
1.
Remove the front wheel and tire (A) from front hub .

Tightening torque:
88.3 ~ 107.9 N.m (9.0 ~ 11.0 kgf.m, 65.1 ~ 79.6 lb-ft)

   
•
Be careful not to damage to the hub bolts when removing the rear wheel and tire (A).

2.
Remove the front assembly.
(Refer to Front Suspension System - "Front Strut Assembly")
3.
Disconnect the front upper arm (A) with the front strut assembly bracket (B) by loosening the bolt.

Tightening torque:
98.1 ~ 117.7 N.m (10.0 ~ 12.0 kgf.m, 72.3 ~ 86.8 lb-ft)

4.
Installation is the reverse of removal.
   
•
Keep mind in upper arm installing angle.
5.
Check the alignment.
(Refer to Tires/Wheels - "Alignment")
Inspection
1.
Check the bushing for wear and deterioration.
2.
Check the ball joint for rotating torque.
    Front Strut Assembly Repair procedures
    Removal 1. Remove the front wheel and tire (A) from front hub . Tightening torque: 88.3 ~ 107.9 N.m (9.0 ~ 11.0 kgf.m, 65.1 ~ 79.6 lb-ft)     • Be careful not to dama ...

    Front Lower Arm Repair procedures
    Removal Remove the lateral arm. 1. Remove the front wheel and tire (A) from front hub . Tightening torque: 88.3 ~ 107.9 N.m (9.0 ~ 11.0 kgf.m, 65.1 ~ 79.6 lb-ft)     • ...

    See also:

    Solenoid Valve Description and Operation
    Description Four air spring solenoid valves (‘-’ control) and one ambient solenoid valve are embedded inside this solenoid valve block as shown in the circuit diagram below. When connecting ...

    Fuel Pressure Sensor (FPS) Specifications
    Specification Pressure(kPa)Output Voltage(V)500.36002.511004.5 ...

    Exhaust Manifold Components and Components Location
    Components 1. Exhaust manifold heat protector2. Exhaust manifold3. Exhaust manifold gasket4. Exhaust manifold stay ...

    Categories

    Hyundai Equus Manuals

    © 2011-2026 Copyright www.heqmanual.com