>

Hyundai Equus: Troubleshooting - General Information - Driveshaft and axle - Hyundai Equus VI 2009-2025 Service ManualHyundai Equus: Troubleshooting

Troubleshooting
Trouble Symptom
Probable cause
Remedy
Vehicle pulls to one side
Scoring of driveshaft ball joint
Replace
Wear, rattle or scoring of wheel bearing
Replace
Defective front suspension and steering
Adjustment or Replace
Vibartion
Wear, damage or bending of driveshaft
Replace
Driveshaft rattle and hub serration
Replace
Wear, rattle or scratching of wheel bearing
Replace
Shimmy
Defective wheel balance
Adjustment or Replace
Defective front suspension and steering
Adjustment or Replace
Excessive noise
Wear, damage or bending of driveshaft
Replace
Rattle of driveshaft and worn hub splines
Replace
Wear, rattle or scoring of wheel bearing
Replace
Loose hub nut
Adjustment or Replace
Defective front suspension and steering
Adjustment or Replace

    Special Service Tools
    Special Service Tools Tool(Number and Name)IllustrationUse09581-11000Piston expanderSpreading the front disc brake piston.09568-2J100Ball joint removerRemoval of the rear assist arm and tie rod e ...

    Front Axle Assembly
    ...

    See also:

    Camshaft Position Sensor (CMPS) Repair procedures
    Inspection 1. Check the signal waveform of the CMPS and CKPS using the GDS. Specification: Refer to “Wave Form” Removal     • DON’T remove the camshaft pos ...

    General Information
    General 1. Basically, all measurements in this manual are taken with a tracking gauge. 2. When a measuring tape is used, check to be sure there is no elongation, twisting or bending. 3. ...

    Reset items
    Items should be reset after the battery has been discharged or the battery has been disconnected. Auto up/down window Sunroof Driver position memory system Trip computer Climate control ...

    Categories

    Hyundai Equus Manuals

    2011-2025 Copyright www.heqmanual.com