Hyundai Equus: ON/OFF Solenoid Valve Repair procedures
Second generation VI (2009–2026) / Hyundai Equus VI 2009-2026 Service Manual / Automatic Transmission System (SBC) / Automatic Transmission Control System / ON/OFF Solenoid Valve Repair procedures
Second generation VI (2009–2026) / Hyundai Equus VI 2009-2026 Service Manual / Automatic Transmission System (SBC) / Automatic Transmission Control System / ON/OFF Solenoid Valve Repair procedures
| Inspection |
| 1. |
Turn ignition switch OFF. |
| 2. |
Disconnect the E Module connector. |
| 3. |
Measure resistance between sensor signal terminal and sensor ground terminal. |
| 4. |
Check that the resistance is within the specification. |
ON/OFF Solenoid Valve Schematic Diagrams
Circuit Diagram
...
Inhibitor Switch Description and Operation
Description
Inhibitor Switch monitors the lever's position(PRND) and is used to control gear setting signals. ...
See also:
Record your key number
The key code number is stamped on the key code tag attached to the key set. Should
you lose your keys, this number will enable an authorized EQUUS dealer to duplicate
the keys easily. Remove the ...
Compressor Description and Operation
Description
The compressor is the power unit of the A/C system.
It is located on the side of engine block and driven by a V-belt of the engine.
The compressor changes low pressure and low tempera ...
Front Hub / Knuckle / Tone Wheel Repair procedures
Replacement
1.
Loosen the wheel nuts slightly.
Raise the vehicle, and make sure it is securely supported.
2.
Remove the front wheel and tire (A) from front hub .
Be ca ...
Categories
Hyundai Equus Manuals
© 2011-2026 Copyright www.heqmanual.com