>
Hyundai Equus: Presure Switch Repair procedures
| Inspection |
| 1. |
Turn ignition switch OFF. |
| 2. |
Disconnect the E Module connector. |
| 3. |
Measure resistance between sensor signal terminal and sensor ground terminal. |
| 4. |
Check that the resistance is within the specification.
|
| Removal |
| 1. |
Draining ATF totally.
(Refer to Hydraulic system - "Fluid") |
| 2. |
Disconnector the E-Module connector (A).
|
| 3. |
Remove the oil pan (A).
|
| 4. |
Remove the valve body assembly (A).
|
| 5. |
Disconnect the pressure switch connector (A).
|
| 6. |
Remove the pressure switch (A).
|
| Installation |
| 1. |
Install in the reverse order of removal.
|
Presure Switch Schematic Diagrams
6 Speed Clutch Control Solenoid Valve Description and OperationWarning message
If the detecting sensor performance is low or overheated by foreign substances
on the rear bumper, the message will appear to notify the driver.
Also, the message may appear when there is heavy ...
Smart Key Unit Repair procedures
Removal
Smart Key Unit
1.
Disconnect the negative (-) battery terminal.
2.
Remove the crash pad lower panel after loosening the mounting screws.
(Refer to Body - "Crash Pad Lower Panel")
...
Steering Column Shroud Panel Components and Components Location
Component Location
1. Steering column shroud lower panel2. Steering column shroud upper panel
...