Hyundai Equus: Input Speed Sensor Description and Operation
Second generation VI (2009–2026) / Hyundai Equus VI 2009-2026 Service Manual / Automatic Transmission System (SBC) / Automatic Transmission Control System / Input Speed Sensor Description and Operation
Second generation VI (2009–2026) / Hyundai Equus VI 2009-2026 Service Manual / Automatic Transmission System (SBC) / Automatic Transmission Control System / Input Speed Sensor Description and Operation
| Description |
Input speed sensor is a vital unit that measures the rate of
rotation of the input shaft inside the transmission and delivers the
readings to the TCM. The sensor provides critical input data that's used
in feedback control, damper clutch control, gear setting control, line
pressure control, clutch activation pressure control, and sensor fault
analysis.
Output Speed Sensor Repair procedures
Inspection
1.
Check signal waveform of output speed sensor using the GDS.
Specification: Refer to "Signal Wave Form" section.
...
Input Speed Sensor Specifications
Specifications
x Type: Hall effect sensor
x Specifications
Operation condition (°C)°F((-)40~150)) -40~302Air gap(mm)in.1.3(0.0512)Output voltageHigh1.4Low0.7
...
See also:
Tire terminology and definitions
Air Pressure:
The amount of air inside the tire pressing outward on the tire. Air pressure
is expressed in pounds per square inch (psi) or kilopascal (kPa).
Accessory Weight:
This means the com ...
Repair procedures
Adjustment
1.
After loosening the trunk lid hinge (A) mounting bolt, adjust the trunk lid by moving it up or down, or right or left.
2.
Adjust the trunk lid height by turning the trunk lid ove ...
GAWR (Gross axle weight rating)
This is the maximum allowable weight that can be carried by a single axle (front
or rear). These numbers are shown on the certification label. The total load on
each axle must never exceed its GAW ...
Categories
Hyundai Equus Manuals
© 2011-2026 Copyright www.heqmanual.com