Hyundai Equus: Oil Filter Repair procedures
Second generation VI (2009–2026) / Hyundai Equus VI 2009-2026 Service Manual / Automatic Transmission System (SBC) / Hydraulic System / Oil Filter Repair procedures
Second generation VI (2009–2026) / Hyundai Equus VI 2009-2026 Service Manual / Automatic Transmission System (SBC) / Hydraulic System / Oil Filter Repair procedures
| Replacement |
| 1. |
Draining ATF totally. |
| 2. |
Remove the oil pan (A).
|
| 3. |
Must be replaced by new oil pan.
|
| 4. |
Adding automatic transmission fluid.
(Refer to "automatic transmission system" in this group.) |
Fluid Repair procedures
Service Adjustment Procedure
Oil level Check
A check of ATF level is not normally required during
scheduled services. If an oil leak is found, perform the oil level chec ...
Valve Body Description and Operation
Description
The valve body is essential to automatic transmission control
and consists of various valves used to control the oil feed from the
oil pump. Specifically, these valves consist of pr ...
See also:
Normal maintenance schedule
The following maintenance services must be performed to ensure good emission
control and performance. Keep receipts for all vehicle emission services to protect
your warranty. Where both mileage a ...
Blind spot detection system (BSD) (If equipped)
The BSD (Blind spot detection) system uses a radar sensor to alert the driver
while driving.
It senses the rear side territory of the vehicle and provides information to
the driver.
(1) BSD (B ...
Body Control Module (BCM) Repair procedures
Removal
1.
Disconnect the negative (-) battery terminal.
2.
Remove the crash pad lower panel after loosening the mounting screws.
(Refer to Body - "Crash Pad Lower Panel")
3.
Disconnect t ...
Categories
Hyundai Equus Manuals
© 2011-2026 Copyright www.heqmanual.com