>

Hyundai Equus: Fuel Pressure Sensor (FPS) Repair procedures - Fuel Delivery System - Engine Control/Fuel System - Hyundai Equus VI 2009-2026 Service ManualHyundai Equus: Fuel Pressure Sensor (FPS) Repair procedures

Inspection
1.
Connect the GDS on the Data Link Connector (DLC).
2.
Check the output voltage of fuel pressure sensor (FPS).

Specification: Refer to “Specification”

Removal
1.
Turn ignition switch OFF and disconnect the negative (-)battery cable.
2.
Folding the rear seat cushion.
3.
Remove the fuel pump service cover (A) after loosening the screws.

4.
Disconnect the fuel pressure sensor connector (A).
5.
Remove the fuel pressure sensor fixing pin (B) in the direction of the arrow .
6.
Remove the fuel pressure sensor (C) from the fuel pump.

Installation
1.
Install in the reverse order of removal.
    Fuel Pressure Sensor (FPS) Troubleshooting
    Fail-Safe Mode ItemFail-SafeDuty (%)85     If the fuel pressure sensor malfunctions, it enters fail safe mode. This means that the fuel pressure rises to match the increasi ...

    Fuel Line Repair procedures
    Removal 1. Turn ignition switch OFF and disconnect the negative (-)battery cable. 2. Release the residual pressure in fuel line. (Refer to Fuel Delivery System - "Release Residual Pressure in ...

    See also:

    Do not let ice and snow accumulate underneath
    Under some conditions, snow and ice can build up under the fenders and interfere with the steering. When driving in severe winter conditions where this may happen, you should periodically check un ...

    Steering Column Shroud Panel Repair procedures
    Replacement [Steering column shroud lower panel]     • Put on gloves to protect your hands.     • When prying with a flat-tip screwdriver, wrap ...

    Electronic Active Headrest Schematic Diagrams
    Circuit Diagram ...

    Categories

    Hyundai Equus Manuals

    2011-2026 Copyright www.heqmanual.com