Hyundai Equus: Fuel Pressure Sensor (FPS) Description and Operation
Second generation VI (2009–2026) / Hyundai Equus VI 2009-2026 Service Manual / Engine Control/Fuel System / Fuel Delivery System / Fuel Pressure Sensor (FPS) Description and Operation
Second generation VI (2009–2026) / Hyundai Equus VI 2009-2026 Service Manual / Engine Control/Fuel System / Fuel Delivery System / Fuel Pressure Sensor (FPS) Description and Operation
| Description |
The fuel pressure sensor (FPS) is installed on top of the low
pressure fuel pump and measures the pressure of the low pressure fuel
line. Based on the current fuel pressure and the amount of fuel
consumed, the fuel pump control module (FPCM) determines whether to
activate the low pressure fuel pump. After activating the low pressure
fuel pump, the FPS continues to communicate with the FPCM to measure the
fuel pressure and control the supply of low pressure fuel.
Fuel Pump Control Module (FPCM) Repair procedures
Inspection
1.
Connect the GDS on the Data Link Connector (DLC).
2.
Check the output voltage of fuel pressure sensor (FPS).
Specification: Refer to “Specification”
...
Fuel Pressure Sensor (FPS) Specifications
Specification
Pressure(kPa)Output Voltage(V)500.36002.511004.5
...
See also:
Accelerator Pedal Repair procedures
Removal
1.
Turn the ignition switch OFF and disconnect the negative (-) battery cable.
2.
Disconnect the accelerator position sensor connector (A).
3.
Disconnect the accelerator control ...
GAW (Gross axle weight)
This is the total weight placed on each axle (front and rear) - including vehicle
curb weight and all payload. ...
This device complies with Part 15 of the FCC Rules.
Operation is subject to the following two conditions:
1. This device may not cause harmful interference, and
2. This device must accept any interference received, including interference that
may c ...
Categories
Hyundai Equus Manuals
2011-2026 Copyright www.heqmanual.com