>
Removal |
1. |
Turn the ignition switch OFF and disconnect the battery negative (-) cable. |
2. |
Release the residual pressure in fuel line.
(Refer to Fuel Delivery System -"Release Residual Pressure in Fuel Line") |
3. |
Remove the fuel pump.
(Refer to Fuel Delivery System - "Fuel Pump") |
4. |
Remove the sub fuel sender.
(Refer to Fuel Delivery System - "Sub Fuel Sender") |
5. |
Disconnect the suction hose (A). |
6. |
Remove the head assembly (C ) after removing the fixing hook (B). |
7. |
Disconnect the dual hose (A). |
8. |
Release the fixing hook, and then remove the free filter (A) and fuel pump motor (B). |
9. |
Remove the over pressure valve assembly (B) from the fuel filter after release the fixing hook (A). |
Installation |
1. |
Install in the reverse order of removal. |
Auto Defogging Sensor Description and Operation
Description
The auto defogging sensor is installed on the front window
glass. The sensor judges and sends signal if moisture occurs to blow out
wind for defogging. The air conditioner control m ...
Components and Components Location
Component Location
1. Fuel filler door open switch2. Fuel filler door release actuator
...
Troubleshooting
Failure Diagnosis
1.
In principle, ESP and TCS controls are prohibited in case of ABS failure.
2.
When ESP or TCS fails, only the failed system control is prohibited.
3.
However, when the ...