>
Hyundai Equus Manuals

Hyundai Equus: Sub Fuel Sender Repair procedures - Fuel Delivery System - Engine Control/Fuel System - Hyundai Equus VI 2009-2026 Service ManualHyundai Equus: Sub Fuel Sender Repair procedures

Second generation VI (2009–2026) / Hyundai Equus VI 2009-2026 Service Manual / Engine Control/Fuel System / Fuel Delivery System / Sub Fuel Sender Repair procedures

Removal
1.
Release the residual pressure in fuel line.
(Refer to Fuel Delivery System - "Release Residual Pressure in Fuel Line")
2.
Folding the rear seat cushion.
3.
Remove the fuel pump service cover (A) after loosening the screws.

4.
Disconnect the sub fuel sender connector (A).
5.
Remove the sub fuel sender (B) from the fuel tank after removing mounting bolts.

Installation
1.
Install in the reverse order of removal.
Sub fuel sender installation bolt :
2.0 ~ 2.9 N.m (0.2 ~ 0.3 kgf.m, 1.4 ~ 2.2 lbf.ft)
   
When installing the sub fuel sender, be careful not to get the seal-ring entangled.
    Fuel Pump Repair procedures
    Removal 1. Release the residual pressure in fuel line. (Refer to Fuel Delivery System - "Release Residual Pressure in Fuel Line") 2. Folding the rear seat cushion. 3. Remove the fuel pump ...

    Fuel Filter Repair procedures
    Removal 1. Turn the ignition switch OFF and disconnect the battery negative (-) cable. 2. Release the residual pressure in fuel line. (Refer to Fuel Delivery System -"Release Residual Pressu ...

    See also:

    Repair procedures
    Inspection [System Inspection] 1. Disconnect the vapor hose from the throttle body and connect a vacuum pump to the nipple on the throttle body. 2. Check the following points with applying ...

    Fuel Tank Pressure Sensor (FTPS) Schematic Diagrams
    Circuit Diagram ...

    Rear Package Tray Trim Components and Components Location
    Component Location 1. Rear package tray trim ...

    Categories

    Hyundai Equus Manuals

    © 2011-2026 Copyright www.heqmanual.com