>

Hyundai Equus: Heated Oxygen Sensor (HO2S) Schematic Diagrams - Engine Control System - Engine Control/Fuel System - Hyundai Equus VI 2009-2026 Service ManualHyundai Equus: Heated Oxygen Sensor (HO2S) Schematic Diagrams

Circuit Diagram

    Heated Oxygen Sensor (HO2S) Troubleshooting
    Signal Waveform Fig.1) The signal waveforms of front HO2S(the upper) and heater(the lower) at idle Fig.2) The signal waveforms of rear HO2S(the upper) and heater(the lower) at idle Fig.3) Typical ...

    Heated Oxygen Sensor (HO2S) Repair procedures
    Inspection 1. Turn the ignition switch OFF. 2. Disconnect the HO2S connector. 3. Measure resistance between the HO2S terminals 3 and 4. 4. Check that the resistance is within the speci ...

    See also:

    Closing the Fuel Filler Lid
    1. To install the fuel tank cap, turn it clockwise until it clicks one time. 2. Close the Fuel Filler Lid until it is latched securely. If the Malfunction Indicator Light ( ) comes ON, turn the eng ...

    Reservoir Tank Description and Operation
    Description The volume is 5.2 liter and the maximum operation pressure is 16bar. (Bursting pressure: 40bar) The pressure of reservoir tank is monitored every 30 min while driving. ...

    Engine compartment fuse replacement
    1. Turn the ignition switch and all other switches off. 2. Remove the fuse panel cover by pressing the tab and pulling up. 3. Check the removed fuse; replace it if it is blown. To remove or insert ...

    Categories

    Hyundai Equus Manuals

    © 2011-2026 Copyright www.heqmanual.com