>
Hyundai Equus: Manifold Absolute Pressure Sensor (MAPS) Repair procedures
| Inspection |
| 1. |
Connect the GDS on the Data Link Connector (DLC). |
| 2. |
Measure the output voltage of the MAPS at idle and IG ON.
|
| Removal |
| 1. |
Turn the ignition switch OFF and disconnect the battery negative (-) cable. |
| 2. |
Disconnect the manifold absolute pressure sensor connector (A). |
| 3. |
Remove the installation bolt (B), and then remove the sensor from the surge tank.
|
| Installation |
|
|
| 1. |
Install in the reverse order of removal.
|
Manifold Absolute Pressure Sensor (MAPS) Schematic Diagrams
Intake Air Temperature Sensor (IATS) Description and OperationPush-starting
Vehicles equipped with automatic transmission cannot be push-started.
Follow the directions in this section for jump-starting. ...
4&OD Clutch Control Solenoid Valve Specifications
Specifications
Direct control VFS[4&OD/C]
x Control type : Normal high type
Control Pressure kpa (kgf/cmx, psi)0~1569.06 (0~16,0~227.57)Current value(mA)0~1100 Internal resistanc ...
Height Sensor Repair procedures
Removal
[Front Height Sensor]
•
Avoid suffering excessive impact.
•
Do not entering the water into pin inside.
•
Take care not to be damaged height senso ...