>

Hyundai Equus: Injector Drive Box (IDB) Repair procedures - Engine Control System - Engine Control/Fuel System - Hyundai Equus VI 2009-2026 Service ManualHyundai Equus: Injector Drive Box (IDB) Repair procedures

Remove
1.
Turn ignition switch OFF and disconnect the negative (-) battery cable.
2.
Remove the IDB cover (A).

3.
Disconnect the IDB Connector (A).
4.
Remove the mounting bolts (B), and then remove the IDB (C).

Installation
1.
Install in the reverse order of removal.

IDB installation bolt:
9.8 ~ 11.8 N.m (1.0 ~ 1.2 kgf.m, 7.2 ~ 8.7 lb-ft)
IDB bracket installation bolt:
9.8 ~ 11.8 N.m (1.0 ~ 1.2 kgf.m, 7.2 ~ 8.7 lb-ft)

    Injector Drive Box (IDB) Schematic Diagrams
    Injector Drive Box (IDB) IDB Connector ECM Terminal Function Connector [C200-IDB] Pin No.DescriptionConnected to1ECM groundChassis ground2ECM groundChassis ground3Battery power (B+)Main rela ...

    ETC (Electronic Throttle Control) System Description and Operation
    Description The Electronic Throttle Control (ETC) System consists of a throttle body with an integrated control motor and throttle position sensor (TPS). Instead of the traditional throttle cab ...

    See also:

    Rear Seat Belt Retractor Components and Components Location
    Component Location 1. Rear seat belt retractor ...

    Description and Operation
    Description Tread Lamp - Tire Under Inflation / Leak Warning. 1. Turn on condition A. When tire pressure is below allowed threshold B. When rapid leak is detected by the sensor. 2 ...

    Record your key number
    The key code number is stamped on the key code tag attached to the key set. Should you lose your keys, this number will enable an authorized EQUUS dealer to duplicate the keys easily. Remove the ...

    Categories

    Hyundai Equus Manuals

    © 2011-2026 Copyright www.heqmanual.com