>

Hyundai Equus: Fuel Tank Air Filter Repair procedures - Evaporative Emission Control System - Emission Control System - Hyundai Equus VI 2009-2026 Service ManualHyundai Equus: Fuel Tank Air Filter Repair procedures

Replacement
1.
Turn the ignition switch OFF and disconnect the negative (-) battery cable.
2.
Remove the service cover (A).

3.
Disconnect the canister close valve connector (A).
4.
Disconnect the vapor hose (B) from the canister.
5.
Remove the installation bolt (C).

6.
Disconnect the vapor hose (A) from the connector assembly (B).
7.
Remove the fuel tank air filter after removing the connector assembly installation bolts (C).

8.
Install a new fuel tank assembly.

Ventilation hose connector assembly installation :
3.9 ~ 5.9 N.m (0.4 ~ 0.6 kgf.m, 2.9 ~4.3 lb-ft)

    Fuel Filler Cap Description and Operation
    Description A ratchet tightening device on the threaded fuel filler cap reduces the chances of incorrect installation, which would seal the fuel filler. After the gasket on the fuel filler cap ...

    Exhaust Emission Control System
    ...

    See also:

    Components and Components Location
    Component Location 1. DDM (Driver Door Module)2. ADM (Assist Door Module)3. IPM (Instrument Panel Module)4. Door lock knob5. Trunk lid actuator6. Front door lock actuator7. Rear door lock actuato ...

    Fuel Filler Door Release Actuator Repair procedures
    Inspection 1. Remove the trunk room left side trim. 2. Open the fuel filler door and remove the housing. (Refer to the BD group - "Exterior")     Do not reuse the fuel fill ...

    Front Impact Sensor (FIS) Description and Operation
    Description The front impact sensor (FIS) is installed in the Front End Module (FEM). They are remote sensors that detect acceleration due to a collision at its mounting location. The primary p ...

    Categories

    Hyundai Equus Manuals

    © 2011-2026 Copyright www.heqmanual.com